Description
The Ferno Model 175 Antler & Rail Wall Mount Kit is the wall mounted member of the Ferno 175 fastening family, made for POWER X1 and 35X cots. It gives the cot its fixed antler and rail interface in the vehicle, the hardware the cot locks against for transport.
- Antler and rail fastening interface
- For Ferno POWER X1 and 35X cots
- Standard wall mount configuration
- Model 175 fastening system hardware
The Fixed Half of the Cot Fastening System
A powered cot is only as secure as the fastener it locks into. The Model 175 system is Ferno long running antler and rail fastening standard, and this kit is its standard wall mount configuration. The antler and rail hardware mounts in the ambulance and presents the interface the cot engages when it loads, holding the cot for transport.
This kit is specified for the POWER X1 and the 35X cots, the two Ferno platforms the 175 wall mount serves. Installers fit it during vehicle build or refit, and it then becomes invisible infrastructure, doing its job on every load cycle. Using the genuine Ferno kit keeps the fastening geometry exactly as the cot was designed and tested around.
Fleets replacing a damaged mount or building out a vehicle to match an existing X1 fleet should use the matched 175 hardware rather than mixing fastening standards. Consistency across vehicles means any cot loads in any unit.
Features and Benefits
- Antler and Rail Interface: the proven Ferno fastening geometry the cot locks against
- Platform Matched: specified for the POWER X1 and 35X cot platforms
- Standard Wall Mount: the wall mounted configuration of the Model 175 system
- Genuine Ferno Hardware: fastening geometry matches the cot design and testing
Product Specifications
Product Details
- Model: Model 175 antler and rail wall mount kit
- Mount Style: standard wall mount
Compatibility
- Designed For: Ferno POWER X1 and 35X ambulance cots
Shop more hospital supplies and other Ferno equipment at MedicalEx.
Why Use the Matched 175 Kit
Fastening is a system, and mixing hardware across standards invites fit and retention problems. The genuine 175 wall mount keeps the X1 or 35X cot on the interface it was built for.
- Exact fastening geometry for the cot
- Supports fleet consistency across vehicles
- The standard wall mount in the 175 range
- Built by Ferno for its own cot platforms
Frequently Asked Questions
Which cots does this mount serve?
The kit is specified for the Ferno POWER X1 and 35X cots. It provides the antler and rail interface those cots lock into.
What is an antler and rail fastener?
It is the Ferno fastening style where a rail and antler shaped hardware in the vehicle captures the cot frame. The system has been a Ferno standard for many years.
Is this the wall mount or floor mount version?
This is the standard wall mount configuration of the Model 175. Ferno also makes floor mount versions in the same system.
Who installs the kit?
The mount is typically installed during ambulance build or refit by the vehicle outfitter. It then serves as fixed vehicle infrastructure for the cot.
Why not use a generic mount?
Cot retention depends on exact fastening geometry. The genuine Ferno kit matches the cot design, which protects both fit and tested performance.
Additional Information
Warranty: |
This product may be covered under the manufacturer’s original warranty. Please refer to the manufacturer’s documentation or contact us for assistance. |